Fridge Repair in Brooklyn — Same-Day Service

If your refrigerator can’t reach or hold the right temperature, food can spoil faster and the compressor may run nonstop. Common causes include dirty condenser coils, blocked airflow, a failing fan, or incorrect thermostat settings.

Start by clearing vents, checking door closure, and cleaning the coils to improve cooling efficiency. If temperatures still won’t stabilize, a technician can test sensors, fans, and the sealed system.

Heavy frost in the freezer while the fridge stays lukewarm usually points to an airflow or defrost problem. Ice can block the evaporator, preventing cold air from circulating into the fresh-food section.

Check that vents aren’t obstructed and that the door is sealing tightly to keep humid air out. If frost quickly returns after a manual defrost, the defrost heater, thermostat, or control board may be failing.

When an ice maker stops dumping cubes, the issue is often a frozen fill tube, low water pressure, or a stuck ejector mechanism. A clogged water filter can also reduce flow and cause incomplete fills that freeze in place.

Try replacing the filter, checking the shutoff arm or switch, and warming the fill tube if it’s iced over. If the unit still won’t cycle, the inlet valve, module motor, or sensors may need service.

Water collecting under the refrigerator is often caused by a clogged defrost drain that can’t channel melted ice away properly. When the drain is blocked, water backs up and spills into the fridge base or onto the floor.

You can often fix this by flushing the drain with warm water and clearing debris, then ensuring the drain tube is properly seated. If the leak returns, the drain heater, drain pan alignment, or internal ice buildup may need professional attention.

A worn or torn door gasket lets cold air escape and warm, moist air enter, which forces the fridge to work harder. This often leads to temperature swings, condensation, and frost buildup around the door area.

Clean the gasket and mating surface, then check for gaps by closing a sheet of paper in the door and feeling for resistance. If the seal is warped or cracked, replacing it is a quick repair that can restore efficiency.